Explore Silicon Valley · Explore Silicon Valley
The tech-ready home.
Checked, not assumed.
You can read a spec sheet for a laptop in a minute. A house does not come with one. This Property Nerds® guide covers the parts of a Silicon Valley home that people in tech tend to ask about: electrical capacity, car charging, solar and batteries, heat pumps, induction cooking and the internet connection.
Every fact below comes from a public agency source: the U.S. Department of Energy, ENERGY STAR, the California Energy Commission, the California Public Utilities Commission, the Bay Area Air District or a city permit office. Rules and dates are stated as of November 2026. The guide explains terms. It does not assess any particular property; a licensed electrician or the city building department confirms the specifics. For the wider picture, start at Explore Silicon Valley.
Start reading ↓In this guide
01 · electrical panel
Start at the panel.
Amps set the ceiling.
The electrical panel is the box of breakers that feeds every circuit in the home. A fact sheet on the U.S. Department of Energy’s building science site puts its job simply: panel capacity decides the maximum amount of power that lights and appliances can draw at any given time. Panel size is set by the current rating of the main breaker and typically runs between 100 and 400 amps.
The same fact sheet says many modern homes have 200-amp panels and that 100-amp panels are common in older homes with no major renovation or addition. It lists three places to read the size: the label on the utility meter box, the label on the panel and the main breaker. ENERGY STAR, the federal efficiency program, adds one more look: empty slots in the panel, which show room for new breakers.
Why it matters for a buyer in tech: Level 2 car charging needs a dedicated 240-volt circuit, and so do electric heating and cooking under California’s electric-ready rules. The fact sheet names two separate limits, physical space for breakers and electrical capacity. It warns that you cannot add up the breaker numbers and subtract them from the panel rating, and says electricians recommend the load stay under 80 percent of service capacity.
A bigger panel is one answer among several. The fact sheet also describes panel optimization: power-efficient appliances, circuit-sharing devices, and smart panels or smart breakers.
Property Nerd note. a 100-amp label is a starting point, not a verdict. A licensed electrician’s load calculation answers the question for a specific home.
02 · ev charging
Charging at home.
Level 1 or Level 2.
The Energy Department’s Alternative Fuels Data Center describes two levels of home charging. The figures below are its approximations.
An existing charger at a home for sale raises one more question: was it installed with a permit? The city’s permit record answers that. Our post on home permit research shows how to look one up, and Getting Around Silicon Valley covers the commute side.
- Level 1
- Charging through a 120-volt plug, at approximately 5 miles of range per hour of charging. It needs a power outlet on a dedicated branch circuit. The Data Center says many electric vehicle owners meet their daily driving needs by charging overnight this way.
- Level 2
- Charging at 240 volts in homes, at approximately 25 miles of range per hour. Residential units commonly operate at up to 30 amps and require a dedicated 40-amp circuit under the National Electric Code.
- Capacity
- Some homes may not have enough electrical capacity for Level 2 equipment. The Data Center says electricians can tell an owner whether the home has adequate capacity.
- Permits
- Permits may be required from the local building and permitting authorities, and an installation must comply with local and state codes. The city building department is the place to ask.
03 · solar and batteries
Solar and batteries.
Read the paperwork.
Rooftop solar in California comes with a billing rule. The California Public Utilities Commission (CPUC) says customers applying to connect a system since April 15, 2023 take service on the net billing tariff. It applies to customers of the three large investor-owned utilities, PG&E among them, and those utilities call it the Solar Billing Plan.
Under net billing, the CPUC explains, credit for excess power sent to the grid is applied to the customer’s bill, and the customer must take service on a specified time-of-use rate. The original customer keeps the tariff for nine years. The older net energy metering tariffs are closed to new enrollments, and a customer on the second of them may stay on it for 20 years from the date the system was connected. So ask for the date the system was connected, and ask the utility which tariff would apply to a new owner.
A battery stores power for later. The Energy Department’s solar guide for homeowners says storage lets you keep energy and use it later in the day, and can help when the power goes out. The same guide notes that with a lease or a power purchase agreement the solar company owns the system, and that a system owned by a third party adds some complexity to a real estate transaction. Ask for the contract early.
Permits are moving online. A state law, Senate Bill 379, requires California cities and counties, apart from small ones, to offer an online, automated permit platform for residential solar systems up to 38.4 kilowatts and for storage paired with them. One such platform is SolarAPP+, a free online tool for local governments developed at a national laboratory with Energy Department funding.
As of November 2026, Palo Alto’s permit office describes its SolarAPP+ permit as an automated code-compliance review for roof-mounted systems on one-unit homes, open to licensed contractors. It does not cover a battery installed alone, a service panel upgrade or a home on a historic register, and the city’s own utility must approve the connection beforehand. This is general information, not financial, tax or legal advice. County-level figures are on our home heating and solar page.
04 · heat pumps and induction
Heat pumps and induction.
What the rules say.
A heat pump uses electricity to move heat from one place to another. The panel fact sheet cited above calls it a single appliance that can replace both an air conditioner and a heating system. A heat pump water heater uses electricity to pull heat from the surrounding air into a hot water tank. With induction cooking, an electromagnetic field heats the cookware itself; the Energy Department says any flat-bottomed pan that a magnet sticks to will work.
For new construction, the rulebook is the California Energy Code, which the California Energy Commission (CEC) updates every three years. Buildings whose permit applications are filed on or after January 1, 2026 must comply with the 2025 code. For homes, the CEC’s fact sheet says the code uses heat pumps for both space heating and water heating as its baseline. It also carries a reminder: the CEC does not mandate specific fuel types.
Where a newly built one-unit home does get gas or propane appliances, the code’s electric-ready rules apply. The CEC lists a 240-volt circuit and reserved breaker space for a future heat pump space heater, a designated space for a future heat pump water heater, a 240-volt circuit for a future electric cooktop and another for an electric dryer. The CEC says these rules do not apply to additions, alterations or new buildings with all-electric appliances.
Replacing a water heater or furnace brings in a different body, the Bay Area Air District. Its rules cover water heaters and furnaces, and the District says they apply to the sale and installation of new equipment after set dates. The dates below are as of November 2026.
- Water heaters
- On November 4, 2026 the Air District board voted to move the zero-NOx date for residential water heaters from January 2027 to January 1, 2028. The standard applies when an owner replaces a water heater. Units of 30 gallons or less and mobile home water heaters are not required to comply.
- Furnaces
- The Air District gives 2029 as the compliance date for its furnace rule. Its fact sheet, written before the November vote, applies the standard to furnaces under 175,000 BTU per hour manufactured after January 1, 2029, with a cost and technology assessment due before then.
- Working appliances
- The District says there is no mandate to remove or replace a working appliance.
- Stoves and dryers
- The water heater standard does not apply to stoves, dryers or fireplaces.
- Exemptions
- The November 2026 amendments add exemptions, including for properties with electrical limits such as a panel below 100 amps, and for properties without the room or ventilation for a compliant unit.
Property Nerd note. the age and fuel of the water heater and furnace are worth writing down at a showing. They tell you which of these dates could matter for that home.
05 · home network
The home network.
Look it up by address.
Fiber or cable? It depends on the exact location, and a listing remark is not proof. A public reference is the Federal Communications Commission’s National Broadband Map. The CPUC describes it as a map that displays where internet services are available across the United States, as reported by providers, and says users can search it by location.
In practice: open the National Broadband Map, search the location and read what is reported there. Then note the words “as reported by providers.” Before you rely on the map, ask a provider to confirm service and connection type for that exact address.
This guide does not state which services reach any city or neighborhood.
Inside the home, look rather than assume. Where does the line enter the building? Is there network cabling between rooms? Is there a spot with power for a modem and router? These are questions for the seller.
06 · home office
A home office.
Questions, not promises.
A room to work in is a matter of fit, and this guide makes no claim about what one adds to a price. How many outlets does the room have? Does the heating and cooling system reach it? Can you close a door?
If the office is a converted garage, an addition or a separate structure in the yard, ask whether the work was done with a permit; our permit research post explains the lookup. To weigh the commute against days worked at home, see Silicon Valley Tech Campuses and the figures in Silicon Valley by the Numbers.
07 · at the showing
At the showing.
What to look for.
A neutral checklist. None of it replaces a home inspection, and a licensed electrician or the city building department confirms the specifics.
New to the vocabulary of the industry as well as the housing stock? Our start-up culture guide explains the terms, and Silicon Valley real estate start-ups covers the tools. For the houses themselves, the Architecture Field Guide sorts the styles, and the step-by-step buying guide covers the process.
The Boyenga Team works with buyers and sellers across the valley; see Tech Professionals or contact us with a question. The Boyenga Team is not affiliated with the companies named on this page. Names are used only to identify places.
- Main breaker
- Read the number on the main breaker and the label on the panel. Note any empty slots.
- Car charging
- Is there a 240-volt outlet or a wall charger in the garage or driveway? Ask for the permit record.
- Solar
- Is the system owned, leased or under a power purchase agreement? Ask for the contract and the date the system was connected to the grid.
- Battery
- Is there one, and was it installed with a permit?
- Water heater and furnace
- Note the fuel, gas or electric, and the age on the label.
- Range
- Gas, electric or induction? Note what kind of outlet sits behind it.
- Internet
- Search the location on the National Broadband Map before the visit, then find where the line enters the home.
- Office space
- Check outlets, heating and cooling, and the permit record for any converted space.
Questions
Common questions.
Plain answers.
Is a 100-amp panel enough for an electric car?
It depends on the home’s whole load, so no general answer exists. The Energy Department’s Alternative Fuels Data Center says some homes may not have enough capacity for Level 2 equipment and that an electrician can tell you. A Level 1 charger uses a 120-volt plug on a dedicated circuit.
Do I need a permit for a home car charger?
The Alternative Fuels Data Center says permits may be required from local building and permitting authorities and that installations must comply with local and state codes. Ask the building department of the city where the home sits.
What is net billing?
It is the tariff that customers of California’s three large investor-owned utilities have taken when applying to connect solar since April 15, 2023, according to the CPUC. Credit for power sent to the grid is applied to the customer’s bill. This is general information, not financial, tax or legal advice.
Do Bay Area rules make me replace a gas water heater?
No. The Bay Area Air District says its standard applies when an owner replaces a water heater and does not require removing a working one. As of November 2026, the date for residential water heaters is January 1, 2028.
Does the California Energy Code require all-electric new homes?
The CEC’s fact sheet for the 2025 code says the Commission does not mandate specific fuel types. The code uses heat pumps as the baseline for space and water heating in new homes and sets electric-ready rules where gas appliances are installed.
How do I check internet service at an address?
Search the location on the Federal Communications Commission’s National Broadband Map, which shows where services are available as reported by providers. Then confirm with the provider.
Your next move
Know the Valley.
Then choose your part of it.
Buying in Silicon Valley
Tell us where you work, how you like to get around and what kind of house you are after. We will help you compare cities and streets with that in mind.
See the buyer advantage ↗ Find your fit ↗Selling in Silicon Valley
Buyers ask about the area as much as the house. We help you present both clearly, from preparation to pricing to launch.
See the seller advantage ↗ What is my home worth? ↗Talk with the Boyenga Team at Compass: (408) 373-1660 or (650) 383-8606, or send us a note.